Iris 106 Uživatelský manuál

IRIS106 MINI PTZ CAMERAUSER GUIDE & INSTALLATION MANUAL IRIS INNOVATIONS LIMITEDUnits 8 & 9 Swanwick Business Centre, Bridge Road, Swanwick, H

OperationNow the camera is installed, powered up from a suitably rated and protected 12VDC power source and the video is hooked up to the monitoring (

at the touch of a button. Refer to the documentation of the controller for details on how to save and recall preset positions.OSD Menu (Extended Featu

Camera Address TableThis table lists the DIP switch set-tings to set address 1 through 75. For information on how to set ad-dresses

Limited WarrantyThis Iris Innovations product is warranted to be free from defects in materials or workmanship for one year from the date of purchase.

Notes:Iris Innovations: IRIS106 User Guide. v1.00 072013

Notes:Iris Innovations: IRIS106 User Guide. v1.00 072013

Iris Innovations LimitedUnits 8 & 9 Swanwick Business CentreBridge Road, Swanwick, Hampshire SO31 7GBUnited KingdomTel: +44(0)1489 570797Iris Inno

Warnings & Regulatory InformationDo not use harsh chemicals or cleaning solvents to clean the device.Do not attempt to dismantle the device.Unauth

IntroductionThe IRIS106 is a fully controllable Pan, Tilt and Zoom CCTV camera with low light operation, designed specifically for use on boats as a s

InstallationTo install the IRIS106 you will need the following tools:• Drill with 105mm Hole Saw• Drill Bit for Pilot Holes (2mm)• Cross Headed Screw

example). If possible, power the item up and offer the camera up in the vicinity of the desired installation position to double check suitability.Cabl

Video DistributionAmplifierIRISVDA0208RS485 SerialData DistributorIRISEXP0204Fig:2.0. Slightly more complex set up with 4 IRIS106 cameras being control

Cabling (continued...)The following cable specifications apply:Video: 75Ω Coaxial Cable such as RG59, URM70, RG174 Mini-Coax.Data: Single Twisted PairP

Camera Address (continued...)The example below (Fig 3.0) shows the camera address set to 1, as switch 1 is set to the ON position as shown by the arro

Fitting the Camera:Step 1: After you have established the desired mounting position and are happy there are no obstacles behind the surface into which