Iris 118 Uživatelský manuál

©2013 Iris Innovation Limited. 116-V1.01! 1116USER GUIDESERIES: 116/117/118

7.01 Controlling the CameraYour camera features positional controls and extended features. Positional features such as Pan, Tilt and Zoom ar

ToursA tour is a group of 10 user preset positions that are linked together so that when activated, the camera will sequence to e

8.01 Protocol Command ListThe table below lists features specific to IRIS116 Series (116,117,118) Cameras that are not covered by the standard P

FunctionValueCommandHAddC1C2D1CHKFastFFAD00390203CHK180˚ Auto Scan (116)SlowFFAD00390301CHKMediumFFAD00390302CHKFastFFAD00390303CHK360˚ Auto Scan (116

9.01 Camera Address TableThe cameras unique device address is set using DIP switch Bank 1. The following table lists switch positions

SpecificationsFeature116117118Camera ModuleSony FCB-EX985ESony FCB-EX985ESony FCB-EX985EVideo SystemPAL / NTSC (not interchangeable - specify at order)

Iris Innovations Limited (UK)Units 8 & 9 Swanwick Business CentreBridge Road, Swanwick. Hampshire SO31 7GBUnited KingdomTel: +44(0)1489 570797emai

2Contents:PAGE! SECTION !3! 1.01! ! INTRODUCTION3! 1.02! ! FEATURES3! 1.03! ! MANUAL VALIDITY3! 1.04! ! IMPORTANT WARRANTY INFORMATION3! 1.05! ! CONVE

1.01 IntroductionIRIS 116, 117 and 118 cameras have been especially designed for practical and extreme operating environments such as mar

2.01 Warnings & Important Product InformationWARNING: Installation and OperationThis product must be installed and operated in accordance wit

3.01 Examples of Typical SystemsA basic configuration will consist of a single camera, a camera controller and a viewing medium (either a d

4.01 Camera Control DataIRIS116 series cameras are controlled via an RS485 serial data connection, using a variant of the Pelco-D CCTV camera contr

5.01 Hardware InstallationThe different parts of your camera are labelled here:Once youʼve established a suitable fixing position, use the fixing p

Hardware InstallationFix camera to mounting plate, routing umbilical cable through cable entry hole, then fix mounting plate to surface

6.01 ConnectionsAs shown in the diagram below, a 3.5 meter ʻumbilicalʼ cable tail extends from the base of the camera and is terminated wi